سليبر تريكو حريمى بضفيرة بالباترون

السلام عليكم ورحمة الله تعالى وبركاته

سليبر تريكو حريمى بضفيرة بالباترون

Felted slippers with cable



Fits shoe size: 35/37 - 38/39 - 40/42 - 42/44
(See diagram M.2 for measurements before and after felting. Numbers without brackets show measurements BEFORE felting. Numbers in brackets show approx.
measurements AFTER felting.)

Materials:200-200-200-250 g deep red.
And use:50-50-50-50 g off white

STRAIGHT NEEDLES SIZE 6 mm – or size needed to get 15 sts x 30 rows in garter st = 10 x 10 cm before felting (approx. 20 sts x 38 rows in garter st = 10 x 10 cm after felting).

CROCHET HOOK SIZE 7 mm

PATTERN:
See diagram M.1 (= 13 sts).
GARTER ST (back and forth on needle):
K all rows.
GUSSET ANKLE:
Beg from RS: * Work 6 sts, turn piece and work 6 sts back (there might be a small hole in the piece but this will even out after felting), work 9 sts, turn piece and work 9 sts back, work 12 sts, turn piece and work 12 sts back, work 16 sts, turn piece and work 16 sts back, work 12 sts, turn piece and work 12 sts back, work 9 sts, turn piece and work 9 sts back, work 6 sts, turn piece and work 6 sts back *. Work 1 row over all sts and work Gusset Ankle from *-* in the opposite side (beg from WS).
GUSSET HEEL:
Work until 12-13-15-16 sts remain before diagram M.1, turn piece and work back while at the same time inc by working 2 sts in the last st on row. Work until 11-12-14-15 sts remain before diagram M.1, turn piece and work back and inc by working 2 sts in the last st on row. Work until 10-11-13-14 sts remain before diagram M.1, turn piece and work back and work 2 sts in the last st
- continue like this until 5-6-8-9 sts remain before diagram M.1 - now stop inc in the last st on row but continue until 2-3-4-5 sts remain before diagram M.1 – then work reversed (i.e. work 1 st less before every turn). When 5-6-8-9 sts remain before diagram M.1, beg working the outermost 2 sts tog - continue until 12-13-15-16 sts remain before diagram M.1.
--------------------------------------------------------

SLIPPER:
The slipper is worked back and forth on needle in garter st. Beg at the top of the leg and finish with the toe. Cast on 49-51-55-57 sts on needle size 6 mm with Nepal. Work 1st row from RS as follows: K 2 tog, 16-17-19-20 sts in garter st, diagram M.1 (= 13 sts), 16-17-19-20 sts in garter st, K 2 tog = 47-49-53-55 sts. Continue with diagram M.1 and 17-18-20-21 sts in garter st in each side. When 1 repetition of diagram M.1 has been worked vertically, work GUSSET ANKLE from RS - see explanation above! After Gusset Ankle has been worked in both sides, continue as before until diagram M.1 has been worked a total of 2 times vertically from cast on edge. REMEMBER THE KNITTING TENSION! Then work GUSSET HEEL from RS - see explanation above! After gusset heel in the right side, work 1 row with pattern over all sts, then work gusset heel in the left side (beg from WS). When gusset heel has been worked in both sides, insert a marker in the outermost st - now measure foot from here. Continue diagram M.1 with garter st in each side, AT THE SAME TIME dec for foot by K 2 tog on each side of diagram M.1 on every row from RS a total of 3-3-4-4 times = 41-43-45-47 sts. Continue over these sts until foot measures 9.5-12-13-15 cm, measured from marker). On next row from RS, work the 13 sts over diagram M.1 as follows: K 2 tog, K 2 tog, K 2 tog, P 1, K 2 tog, K 2 tog, K 2 tog = 35-37-39-41 sts on needle. Work in garter st over all sts until finished measurements. Now dec for toes as follows: Dec 4 sts evenly on row by K tog sts 2 by 2 a total of 4 times on row = 31-33-35-37 sts. K 9-9-11-11 rows. On next row from RS, dec 6 sts evenly = 25-27-29-31 sts. K 5-5-7-7 rows. On next row from RS, dec 4 sts evenly = 21-23-25-27 sts. K 3 rows in all sizes. Work next row as follows: K 1, then work the remaining sts K tog 2 by 2 = 11-12-13-14 sts on row. Cut the thread and pull it through the remaining sts and tighten tog.

ASSEMBLY:
Sew tog mid under foot, from toe and up to cast on edge, sew edge to edge (in front loop of sts) to avoid a chunky seam.

CROCHET BORDER:
Crochet with off white Puddel on hook size 7 mm. Work around the edge as follows: * 1 dc, 2 ch, skip 1 cm *, repeat from *-* around the edge, finish with 1 sl st in first dc.

FELTING:
Place the slippers in the washing machine with a detergent without enzymes and optical bleach. Wash at 40 degrees with normal spin but no pre-wash. After wash shape the slippers to the right measurements while still wet and leave to dry flat. At subsequent wash, wash the slippers at regular wool programme.