باترون بونشو تريكو مثلث بضفيرة وغرزة لاسيه بالباترون

بسم الله الرحمن الرحيم

باترون بونشو تريكو مثلث بضفيرة وغرزة لاسيه بالباترون

Knitted poncho with cables and lace pattern



Size: S/M - M/L - L/XL - XXL/XXXL

Materials: 450-500-550-600 g orange

CIRCULAR NEEDLE (60 or 80 cm) SIZE 5.5 mm - or size needed to get 16 sts x 20 rows in stocking st = 10 x 10 cm.
CIRCULAR NEEDLE (60 or 80 cm) SIZE 4.5 mm - for edges in garter st.

GARTER ST (back and forth on needle):
K all rows. 1 ridge = 2 rows K.

PATTERN:
See diagrams A.1 to A.3. Diagrams show all rows seen from RS.
----------------------------------------------------------

PONCHO:
Worked in two parts that are sewn tog when finished. Each part is worked back and forth on circular needle.

PART 1: Cast on 66-74-80-86 sts on circular needle size 4.5 mm with Nepal. Work 12 rows in GARTER ST - see explanation above (1st row = WS). Switch to circular needle size 5.5 mm and work next row as follows from WS: K 6-6-6-8, P 4, * 1 YO, P 1 *, repeat from *-* 2 more times (= 3 sts inc – NOTE: On next row K YO twisted to avoid holes), P until 13-13-13-15 sts remain, * P 1, 1 YO *, repeat from *-* 2 more times (= 3 sts inc) and finish with P 4 and K 6-6-6-8 = 72-80-86-92 sts. Then work pattern as follows beg from RS: 6-6-6-8 edge sts in garter st, K 2, P 2, diagram A.1 (= 6 sts), P 2, K 2, P 3-4-5-5, K 2-3-3-4, P 3-4-5-5, diagram A.3 (= 16-18-20-20 sts - choose diagram for your size), P 3-4-5-5, K 2-3-3-4, P 3-4-5-5, K 2, P 2, diagram A.2 (= 6 sts), P 2, K 2 and 6-6-6-8 edge sts in garter st. Continue the pattern like this. REMEMBER THE KNITTING TENSION! When piece measures approx. 61-68-74-80 cm - adjust so that next row is worked from RS and no more than 3 or 5 rows have been worked after a cable in A.1 and A.2 – K 1 row from RS while AT THE SAME TIME K sts in A.1 tog 2 by 2 and K sts in A.2 twisted tog 2 by 2 = 66-74-80-86 sts. Switch to circular needle size 4.5 mm and work 12 rows in garter st, then loosely cast off with K from WS, piece measures approx. 65-72-78-84 cm.


PART 2: Cast on and work as part 1.

ASSEMBLY:
Place cast off edge on part 1 towards right long side on part 2 - bottom towards cast on edge and 41-46-50-54 cm upwards – make sure that the piece is not stretched too much. Sew the 2 parts tog with neat little sts. Then sew cast off edge on part 2 to right side on part 1 the same way.

SOFT NECK:
Work a neck edge with a "scarf" on each side of opening at the front as follows (scarfs are sewn tog mid back at the end):
Insert 2 markers at the front of neck, approx. 5-5-6-7 cm from tip mid front and up, measure along each side of neck.
LOOSELY cast on 72-78-86-92 sts on circular needle size 4.5 mm, then knit up from RS, approx. 54 to 68 sts around the neck (beg at one marker at the front and finish at the other marker), then LOOSELY cast on 72-78-86-92 new sts at end of row = approx. 198-252 sts. Work in garter st back and forth until neck edge measures 7-7-8-9 cm. Now work short rows to make the edge higher at the back of neck as follows: K 68-74-82-88, slip these sts on a stitch holder, K the rest of row, turn, K 68-74-82-88, slip these sts on a stitch holder, K the rest of row, * turn, K 6-7-7-8, slip these sts on a stitch holder, K the rest of row, turn piece, K 6-7-7-8 sts, slip these sts on a stitch holder and K the rest of row *, repeat from *-* 2 more times. Now slip sts from stitch holder back on needle and continue in garter st back and forth over all sts until neck edge measures approx. 9-9-10-11 cm on the most narrow (i.e. at the outer edge in each side). Then very loosely cast off.
Cross the two "scarfs" mid front, over the shoulder and until mid back so that the short sides meet mid back. Sew short sides tog edge to edge in front loop of outermost sts. Neck edge now lies soft around the opening of the poncho.