بونشو تريكو فخم بضفيرة وعقد بالباترون

بسم الله الرحمن الرحيم

بونشو تريكو فخم بضفيرة وعقد بالباترون
البونشو مميز وجميل وسوف تتمنى ان ترتديه دائما فى كل مكان

Knitted poncho with cables and textured pattern



Size: S - M - L - XL - XXL - XXXL
Materials:750-850-900-1000-1100-1200 g , tan

CIRCULAR NEEDLE (60 and 80 cm) SIZE 9 mm - or size needed to get 10 sts x 18 rows with pattern according to diagram A.4 = 10 x 10 cm.

GARTER ST (in the round on circular needle):
* K 1 round and P 1 round *, repeat from *-*.

GARTER ST (back and forth on needle):
K all rows. 1 ridge = 2 rows K.

PATTERN:
See diagrams A.1 to A.7. Diagrams show all rows seen from RS.

MEASURING TIP:
All length measurements are made in A.4.

DECREASE TIP 1 (applies to dec in diagram A.4):
All dec are done from RS!
DEC AS FOLLOWS AFTER MARKER:
When first st is K: Slip 1 st as if to K, K 1, psso.
When first st is P: P 2 twisted tog.
DEC AS FOLLOWS BEFORE MARKER:
When last st is K: K 2 tog.
When last st is P: P 2 tog.

DECREASE TIP 2 (applies to dec in P sts):
All dec are done from RS.
DEC AS FOLLOWS AFTER MARKER: P 2 twisted tog.
DEC AS FOLLOWS BEFORE MARKER: P 2 tog.
----------------------------------------------------------

PONCHO:
Worked in the round on circular needle from bottom up - READ MEASURING TIP.
Cast on 194-202-218-226-234-258 sts on circular needle size 9 mm with Eskimo. K 1 round. Work next round as follows: Work diagram A.1 (choose diagram for your size = 39-39-39-39-43-43 sts), * K 2, P 2 *, repeat from *-* over the next 56-60-68-72-72-84 sts, K 2, diagram A.1 (= 39-39-39-39-43-43 sts), * K 2, P 2 *, repeat from *-* until 2 sts remain and finish with K 2.
When A.1 has been worked 1 time vertically there are now 214-222-238-246-254-278 sts on needle and piece measures approx. 4 cm.
Now insert 4 markers in the piece as follows: Insert 1st marker at beg of round, 2nd marker after 49-49-49-49-53-53 sts (i.e. after A.1 on back piece), insert 3rd marker after another 58-62-70-74-74-86 sts (i.e. before A.1 on front piece) and insert 4th marker after another 49-49-49-49-53-53 sts (i.e. after A.1 on front piece) = 58-62-70-74-74-86 sts after last marker.
READ ALL OF THE FOLLOWING SECTION BEFORE CONTINUING:
Then work as follows: Work diagram A.2 (= 16 sts), P 17-17-17-17-21-21, diagram A.3 (= 16 sts), diagram A.4 over the next 58-62-70-74-74-86 sts, diagram A.2 (= 16 sts), P 17-17-17-17-21-21, diagram A.3 (= 16 sts) and diagram A.4 over the last 58-62-70-74-74-86 sts on round.
AT THE SAME TIME on 2nd round with A.2 and A.3, dec 1 st after 2nd and 4th marker and 1 st before 3rd and 1st marker – READ DECREASE TIP 1 (= 4 sts dec). Repeat dec every 6th round, 11-11-10-10-11-9 more times and then every other round a total of 14-16-21-23-22-30 times (i.e. that section with A.4 in each side gets smaller and smaller – NOTE: When dec the pattern will not fit in the sides the entire way but make sure that the pattern fits otherwise.
AT THE SAME TIME when A.2 and A.3 have been worked 1 time vertically, work next round as follows: Work diagram A.5 instead of A.2 (= 16 sts), P 2-2-2-2-4-4, A.7 (= 13 sts), P 2-2-2-2-4-4, diagram A.6 instead of A.3 (= 16 sts), diagram A.4 until 3rd marker, diagram A.5 (= 16 sts), P 2-2-2-2-4-4, A.7 (= 13 sts), P 2-2-2-2-4-4, diagram A.6 (= 16 sts) and diagram A.4 over the last sts on round. Continue pattern like this.
AT THE SAME TIME when piece measures 43-43-44-45-46-47 cm, insert 1 marker on each side of the middle 17-17-17-17-21-21 sts at the front and back, i.e. on each side of section with P sts and bobbles. Now dec 1 st on each side of this section – READ DECREASE TIP 2 (= 4 sts dec). Repeat dec every 4th round 5-5-5-5-7-7 more times (i.e. that middle section with P sts and bobbles mid front and mid back gets smaller and smaller).
AT THE SAME TIME when piece measures 48-49-50-51-52-53 cm, dec all 2 P sts in diagram A.5 and A.6 to 1 P st (P sts tog).
AT THE SAME TIME when piece measures approx. 50-52-54-56-58-60 cm - adjust so that next round is 1st-3rd-5th or 7th round in A.5/A.6 (last bobble in diagram A.7 should now be done, i.e. that when diagram A.7 has been worked 3 times vertically, continue in reverse stocking st (seen from RS) over the middle sts in "berry pattern") - inc 1 st in the middle P st at mid front on poncho by P 2 sts in front and back loop of 1 st.
Then work 2 ridges in GARTER ST – see explanation above, over the middle 6 sts mid front (work the other sts as before). On next round after the 2 ridges, divide the piece mid front for neck vent and work back and forth on needle until finished measurements. NOTE: Work 1st row from RS and continue pattern as before but work the outermost 3 sts in each side in garter st.
Continue to work until piece measures approx. 59-61-63-65-67-69 cm. On next row from RS, work sts in the 2 cables in A.5 K twisted tog 2 by 2 (= 4 sts dec) and sts in the 2 cables in A.6 K tog 2 by 2 (= 4 sts dec), in addition dec 12-12-10-10-8-8 sts evenly over the other sts (do not dec over the 3 sts in garter st in each side). After all dec are done, 47-47-49-49-51-51 sts remain on needle. K 1 row from WS.

HOOD:
Worked back and forth on circular needle from vent mid front. K 1 row from RS while AT THE SAME TIME inc 5-5-3-7-5-9 sts evenly (do not inc over the 3 sts in garter st in each side) = 52-52-52-56-56-60 sts. Then work pattern according to diagram A.4 with 3 sts in garter st in each side towards mid front until hood measures approx. 34-34-36-36-38-38 cm. Loosely cast off.

ASSEMBLY:
Sew hood tog at the top.