جوانتى تريكو رجالى برسمة جاكار على شكل نجمة بالباترون

بسم الله الرحمن الرحيم

جوانتى تريكو رجالى برسمة جاكار على شكل نجمة بالباترون

Knitted mittens with star pattern



Size: M - L
Materials:100 g for both sizes colour no 05, black
50 g for both sizes colour no 01, off-white

double pointed needles size 3.5 mm – or size needed to get 22 sts x 30 rows in stocking st = 10 x 10 cm.

Pattern: See diagram M.1 to M.3. Diagram shows the pattern from the RS. The entire pattern is worked in stocking st.

Right mitten: Worked in the round on double pointed needles.
Cast on 48-56 sts on double pointed needles size 3.5 mm with black and work 1.5 cm stocking st. Work next round as follows: * K2 tog, 1 YO *, repeat from *-* (= folding edge). Work 1.5 cm stocking st and now continue in rib, K2/P2.
When rib measures 5 cm continue in rib as follows and now measure piece from here: * 1 round off-white, 2 rounds black *, repeat from *-* a total of 4 times, at the same time dec 4-4 sts evenly on the last black round = 44-52 sts.
After the rib work next round as follows:
M.1 (= 5 sts), M.2 (= 17-21 sts), M.1, M.3 on the next 17-21 sts. (M.2 = upper hand). Remember the knitting tension! Insert a marker in st 28-32 (= first st in M.3) to mark the thumb.
When piece measures 5 cm inc 1 st on each side of st with marker on every 3 round a total of 6-7 times = 56-66 sts – incorporate the inc sts in M.3 as you go along.
When piece measures 10.5-11 cm slip the 12-14 inc sts + st with marker (=13-15 sts) on a stitch holder. On next round cast on 1 new st behind stitch holder = 44-52 sts. Continue in pattern until piece measures 17-18 cm (3-4 cm left) and now dec on both sides of M.1 on every round by K 2 tog each side (= 4 dec per round) a total of 10-11 times = 4-8 sts left.
Cut the thread, pull through remaining sts and fasten.

Thumb: Slip the 13-15 thumb sts back on double pointed needles and pick up 1 st behind thumb. Work M.3, at the same time inc 2-4 sts evenly on first round = 16-20 sts. Work 6.5-7 cm of M.3, on next round K all sts tog 2 by 2, cut the thread, pull through remaining sts and fasten.

Left mitten: Cast on and work like right mitten, but mirrored, i.e. insert marker for thumb in the last st in M.3.