بلوفر تريكو بناتى بغرزة الطوق والغرز الساقطة بالباترون

بلوفر-تريكو-بناتى-غرزة الطوق-غرز ساقطة-بالباترون-بلوفرات-بلوزات-بديهات-جواكت-تريكو-حريمى-باترونات-غرز تريكو

بلوفر تريكو بناتى بغرزة الطوق والغرز الساقطة بالباترون

بسم الله الرحمن الرحيم

Knitted jumper in garter st with dropped sts and ¾ sleeves



Size: S - M - L - XL - XXL - XXXL
Materials:
100-100-100-100-100-150 g colour no 12, peach
100-100-100-100-100-150 g colour no 13, raspberry
100-100-100-100-100-150 g colour no 55, cerise
100-100-150-150-150-150 g colour no 21, beige
50-50-100-100-100-100 g colour no 02, medium pink
50-50-50-50-50-50 g colour no 10, yellow
50-50-50-50-50-50 g colour no 11, strong yellow.
50-50-50-50-50-50 g colour no 20, rust

STRAIGHT NEEDLES SIZE 6 mm - or size needed to get 15 sts x 17 rows in pattern according to A.1/A.2 with 2 threads = 10 x 10 cm.
CIRCULAR NEEDLE SIZE 5 mm (40 cm) - for neck edge.

GARTER ST (back and forth on needle):
K all rows. 1 ridge = 2 rows K.

PATTERN:
See diagrams A.1 and A.2. Diagrams show all rows in pattern seen from RS. NOTE: To avoid the piece being to tight in the sides when working pattern, make 2 YOs inside edge st in each side on every row with dropped sts (instead of 1 YO). Slip both YOs off the needle on next row.

STRIPES:
Change colour on every row marked with arrow in A.1 and A.2. Work the stripes in the following order:
A.1:
1 thread rust + 1 thread raspberry
1 thread raspberry + 1 thread peach
2 threads raspberry
1 thread raspberry + 1 thread peach
1 thread peach + 1 thread cerise
1 thread cerise + 1 thread medium pink
2 threads cerise
1 thread cerise + 1 thread medium pink
A.2:
1 thread medium pink + 1 thread beige
2 threads beige
1 thread beige + 1 thread strong yellow
1 thread beige + 1 thread yellow

MEASURING TIP:
Because of the texture on the garment the piece must be held up when measuring otherwise the jumper will be too long when worn.
----------------------------------------------------------

FRONT PIECE:
READ ALL OF THE FOLLOWING SECTION BEFORE CONTINUING!
Cast on 63-69-75-83-91-99 sts on needle size 6 mm with 1 thread rust + 1 thread raspberry. Work in GARTER ST - see explanation above - for 2-2-3-3-4-4 cm. Then work PATTERN according to diagram A.1 with 1 edge st in garter st in each side (1st row = RS), AT THE SAME TIME work STRIPES - see explanation above. REMEMBER THE KNITTING TENSION!
NOTE: Diagram A.1 is repeated 2 times vertically (until stripes in A.1 are done). After A.1 change to 1 thread medium pink + 1 thread beige. Work in stocking st with 1 edge st in garter st in each side until piece measures 34-35-36-37-38-39 cm - READ MEASURING TIP. Then work pattern according to diagram A.2 AT THE SAME TIME continue with STRIPES - see explanation above. When stripes in A.2 are done, continue pattern with the colours in last stripe (1 thread beige + 1 thread yellow) until finished measurements. AT THE SAME TIME when piece measures 39-40-41-42-43-44 cm - remember MEASURING TIP, insert 1 marker in each side (marks depth of armhole). When piece measures 48-50-52-52-54-56 cm, cast off the middle 21-21-23-23-25-25 sts for neck and finish each shoulder separately. Then cast off at beg of every row from neck: 2 sts 1 time and 1 st 1 time = 18-21-23-27-30-34 sts remain on shoulder. Continue to work until piece measures 53-55-57-59-61-63 cm, work 1 ridge and loosely cast off, piece measures approx. 54-56-58-60-62-64 cm. Repeat on the other shoulder.

BACK PIECE:
Cast on and work as front piece. Mark the depth of armhole as on front piece. Continue to work until piece measures 52-54-56-58-60-62 cm. Now cast off the middle 25-25-27-27-29-29 sts for neck and finish each shoulder separately. Continue to cast off 1 st on next row from neck = 18-21-23-27-30-34 sts remain on the shoulder. When piece measures 53-55-57-59-61-63 cm, work 1 ridge before loosely casting off all sts. Repeat on the other shoulder.

ASSEMBLY:
Sew the shoulder seams.

SLEEVE:
Knit up from RS 45-47-51-53-57-59 sts between the 2 markers in one side of jumper on needle size 6 mm with 1 thread yellow + 1 thread beige. NOTE: If more/fewer sts have been knitted up, dec/inc evenly on 1st row to the correct no of sts.
READ ALL OF THE FOLLOWING SECTION ON SLEEVE BEFORE CONTINUING!
Work PATTERN according to diagram A.2 with 1 edge st in garter st in each side, AT THE SAME TIME work STRIPES – see explanation above but beg at the top of diagram (1st row = WS) and reversed in stripes and work downwards so that you beg with yellow at the top of sleeve and work down towards the rust red. When A.2 has been worked 1 time vertically, change to 1 thread cerise + 1 thread medium pink and continue with A.1 and STRIPES the same way (beg at the top of diagram and reversed in stripes).
AT THE SAME TIME when piece measures 2-2-3-3-4-4 cm from markers, dec 1 st in each side. Repeat dec in each side every 9-7-5½-4½-3½-3 cm 4-5-6-7-8-9 more times (= 5-6-7-8-9-10 dec in total) = 35-35-37-37-39-39 sts. Continue to work until sleeve measures 47-46-45-44-42-40 cm from markers - remember MEASURING TIP. Work 2 ridges with 1 thread raspberry + 1 thread rust and cast off.
Work the other sleeve the same way.

ASSEMBLY:
Sew underarm and side seams in one in front loop of outermost st.

NECK:
Knit up approx. 70 to 85 sts around the neck on circular needle size 5 mm with 1 thread yellow + 1 thread beige. P 1 round and K 1 round, then loosely cast off with P.