شال تريكو حريمى بغرزة الطوق ووحدات من باترون المروحة

بسم الله الرحمن الرحيم

شال تريكو حريمى بغرزة الطوق ووحدات من باترون المروحة

Knitted shawl in garter st with fan pattern



Measurements:
Width at the top: approx. 180 cm
Length on the middle: approx. 65 cm

Materials:300 g rose mist

CIRCULAR NEEDLE (40 or 60 cm) SIZE 4 mm - or size needed to get 21 sts x 40 rows in garter st = 10 x 10 cm.
2 DOUBLE POINTED NEEDLES SIZE 3.5 mm - for edges in garter st.

GARTER ST (back and forth on needle):
K all rows. 1 ridge = 2 rows K.
----------------------------------------------------------

SHAWL:
The shawl consists of several fans knitted together along the way. Beg at the bottom of shawl with fan 1 – see diagram A.1. Then work fan 2 as explained below. Then work fan 3 etc.

FAN 1:
Worked back and forth on circular needle.
Cast on 61 sts on circular needle size 4 mm with Fabel and work as follows:
ROW 1 (= RS): K all sts.
ROW 2 (= WS): K all sts.
ROW 3: K 2 tog, K 9, * slip 1 st as if to K, K 2 tog, psso, K 6 *, repeat from *-* 5 times in total, K 3, K 2 tog = 49 sts.
ROW 4-7: K all sts.
ROW 8 (= WS): K 1, * 1 YO, P 2 tog *, repeat from *-* the entire row = 49 sts.
ROW 9-10: K all sts.
ROW 11: K 2 tog, K 7, * slip 1 st as if to K, K 2 tog, psso, K 4 *, repeat from *-* 5 times in total, K 3, K 2 tog = 37 sts.
ROW 12-15: K all sts.
ROW 16 (= WS): K 1, * 1 YO, P 2 tog *, repeat from *-* the entire row = 37 sts.
ROW 17-18: K all sts.
ROW 19: K 2 tog, K 5, * slip 1 st as if to K, K 2 tog, psso, K 7 *, repeat from *-* 2 times in total, slip 1 st as if to K, K 2 tog, psso, K 5, K 2 tog = 29 sts.
ROW 20-26: K all sts.
ROW 27: K 2 tog, K 3, * slip 1 st as if to K, K 2 tog, psso, K 5 *, repeat from *-* 2 times in total, slip 1 st as if to K, K 2 tog, psso, K 3, K 2 tog = 21 sts.
ROW 28-29: K all sts.
ROW 30 (= WS): K 1, * 1 YO, P 2 tog *, repeat from *-* the entire row = 21 sts.
ROW 31-34: K all sts.
ROW 35: K 2 tog, K 7, slip 1 st as if to K, K 2 tog, psso, K 7, K 2 tog = 17 sts.
ROW 36-42: K all sts.
ROW 43: K 2 tog, K 5, slip 1 st as if to K, K 2 tog, psso, K 5, K 2 tog = 13 sts.
ROW 44-48: K all sts.
ROW 49: K 2 tog, K 3, slip 1 st as if to K, K 2 tog, psso, K 3, K 2 tog = 9 sts.
ROW 50-54: K all sts.
ROW 55: K 2 tog, K 1, slip 1 st as if to K, K 2 tog, psso, K 1, K 2 tog = 5 sts.
ROW 56-58: K all sts.
ROW 59: K 1, slip 1 st as if to K, K 2 tog, psso, K 1 = 3 sts.
ROW 60: K all sts.
ROW 61: Slip 1 st as if to K, K 2 tog, psso = 1 st. Cut the thread and pull it through the remaining st and fasten.

FAN 2:
Cast on 30 sts on needle, knit in addition up 31 sts along the right edge on FAN 1 (seen from RS) – i.e. knit up 1 st in every ridge and approx. 1 st in every row with holes = 61 sts on row.
Then work as FAN 1 but from 2nd row (i.e. beg with K from WS).

FAN 3:
Knit up 31 sts along the left edge on FAN 1 (seen from RS), then cast on 30 new sts at the end of row = 61 sts. Then work as FAN 1 but from 2nd row (i.e. beg with K from WS).

FAN 4:
Work as FAN 2.

FAN 5:
Knit up 30 sts along the left edge on FAN 2 (seen from RS), knit up 1 st at the tip at the top on FAN 1 and knit up 30 sts along the right edge on FAN 3 = 61 sts. Then work as FAN 1 but from 2nd row (i.e. beg with K from WS).

FAN 6:
Work as FAN 3.

First, second and third row with fans have been worked. Continue like this upwards - see diagram A.1 for correct order. When a total of 36 fans have been worked, work half circles between every fan so that the edge at the top of shawl is straight.

HALF CIRCLE BETWEEN EVERY FAN:
Knit up from RS 61 sts along the edge between 2 fans – i.e. knit up 1 st in every ridge and approx. 1 st in every row with holes + 1 st between two fans at the tip at the top of fan from the row below.
Then work as follows:

ROW 1 (= WS): K all sts.
ROW 2 (= RS): K all sts.
ROW 3: K all sts.
ROW 4: * K 3, K 2 tog *, repeat from *-* until 1 st remains and finish with K 1 = 49 sts.
ROW 5: K 1, * 1 YO, P 2 tog *, repeat from *-* the entire row = 49 sts.
ROW 6: K all sts.
ROW 7 (= WS): K 1, * 1 YO, P 2 tog *, repeat from *-* the entire row = 49 sts.
ROW 8-14: K all sts.
ROW 15 (= WS): K 1, * 1 YO, P 2 tog *, repeat from *-* the entire row = 49 sts.
ROW 16-17: K all sts.
ROW 18: K all sts tog 2 by 2 until 1 st remains, finish with K 1 = 25 sts.
ROW 19-25: K all sts.
ROW 26: K all sts tog 2 by 2 until 1 st remains, finish with K 1 = 13 sts.
ROW 27: K all sts.
ROW 28: K all sts tog 2 by 2 until 1 st remains, finish with K 1 = 7 sts.
ROW 29: K all sts.
ROW 30: K all sts tog 2 by 2 until 1 st remains, finish with K 1 = 4 sts.
ROW 31: K all sts.
ROW 32: Slip 1 st as if to K, K 3 tog and psso = 1 st. Cut the thread and pull it through the remaining st, tighten tog and fasten.

HALF CIRCLE ON THE RIGHT EDGE OF SHAWL (seen from RS):
Cast on 30 sts on needle, knit in addition up 31 sts along the right edge on FAN 29 (seen from RS) = 61 sts on row.
Then work HALF CIRCLE BETWEEN EVERY FAN.

HALF CIRCLE ON THE LEFT EDGE OF SHAWL (seen from RS):
Knit up 31 sts along the left edge on FAN 36 (seen from RS), and cast on 30 new sts at the end of row = 61 sts. Then work HALF CIRCLE BETWEEN EVERY FAN.

EDGE IN GARTER ST AT THE TOP OF SHAWL:
Cast on 4 sts on 1 double pointed needle size 3.5 mm.
K 1 row (= RS). Work next row as follows from WS: * Pick up the outermost st in garter st ridge in the left side of shawl (with WS towards you), work first st on left needle, pass the new st over, K the rest of row, turn piece, K back over the 4 sts, turn piece *, repeat these 2 rows from *-* until 1 st has been knitted up in approx. every st in garter st ridges along the entire edge at the top of shawl. Cut and fasten the threads.