STRAIGHT NEEDLES SIZE 4.5 mm - or size needed to get 17 sts in diagram A.1 = width 10 cm with Cotton Light. CROCHET HOOK SIZE 4.5 mm - for crochet edge.
GARTER ST: K back and forth on all rows. 1 ridge = 2 rows K.
PATTERN: See diagrams A.1 and A.2. Diagram A.1 shows all rows in 1 pattern repetition seen from RS. --------------------------------------------------------
BOLERO: Worked back and forth on needle. Cast on 55-55-59-63-67-71 sts on needle size 4.5 mm with Cotton Light. Work 6 rows in GARTER ST - read explanation above. Work next row from RS as follows: 1 edge st in garter st, work A.1 (13-13-14-15-16-17 times in total) until 2 sts remain on row, finish with 1st st in A.1 and 1 edge st in garter st. Continue like this with pattern and 1 edge st in garter st in each side. REMEMBER THE KNITTING TENSION! When piece measures approx. 57-59-61-63-65-67 cm (finish with 2nd row in A.1), work in garter st over all sts. When 3 ridges have been worked, loosely cast off all sts (piece measures approx. 58-60-62-64-66-68 cm).
ASSEMBLY: Sew tog for sleeves as follows (see chart): Place point a against point b, sew inside 1 edge st 8-7-6-5-4-4 cm from cast on edge in towards the middle. Repeat with point c against point d on the other side.
CROCHET EDGE: Worked in the round. With hook size 4.5 mm and beg mid under a sleeve, work dc around the entire opening between sleeves (work approx. 4 dc over 6 rows) - no of dc should be divisible by 8. NOTE! Work enough dc to avoid a tight edge. On next round, work as follows: 1 ch, * 1 dc in next dc, 3 ch, 1 dc in same dc, 1 ch, skip 3 dc, in next dc work 5 tr with 1 ch between every tr, 1 ch, skip 3 dc *, repeat from *-* the entire round - see diagram A.2, finish with 1 sl st in 1st dc from beg of round, cut and fasten the thread.
لا تستطيع كتابة مواضيع جديدة في هذا المنتدى لا تستطيع كتابة ردود في هذا المنتدى لا تستطيع تعديل مشاركاتك في هذا المنتدى لا تستطيع حذف مشاركاتك في هذا المنتدى لا تستطيع إرفاق ملف في هذا المنتدى
